2-6 Clutch Piston Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: 2-6 Clutch Piston

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	2-6 Clutch Piston Procedure DT-46621 seal protector prevents the piston seal lip from damage over the retaining ring groove during installation. Apply a thin coat of ATF to the O.D. of DT-46621 seal protector to ease the installation of the piston. Special Tools DT-46621 Seal Protector For equivalent regional tools, refer to Special Tools .
2	2-6 Clutch Spring Assembly
3	2-6 Clutch Spring Assembly Procedure Install the retaining ring with the opening positioned to the top of the case cover. Place the retainer ring inside DT-46632 spring compressor prior to placing DT-46632 spring compressor onto the spring. Special Tools DT-46632 Spring Compressor For equivalent regional tools, refer to Special Tools .

Callout

Component Name

2-6 Clutch Piston
Procedure
DT-46621 seal protector prevents the piston seal lip from damage over the retaining ring groove during installation. Apply a thin coat of ATF to the O.D. of DT-46621 seal protector to ease the installation of the piston.
Special Tools
DT-46621 Seal Protector
For equivalent regional tools, refer to Special Tools .

2-6 Clutch Spring Assembly

Procedure

Install the retaining ring with the opening positioned to the top of the case cover.
Place the retainer ring inside DT-46632 spring compressor prior to placing DT-46632 spring compressor onto the spring.

Special Tools
DT-46632 Spring Compressor
For equivalent regional tools, refer to Special Tools .