1-2-3-4 Clutch Plates and Low Reverse Clutch Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: 1-2-3-4 Clutch Plates And Low Reverse Clutch Installation Order

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
1	1-2-3-4 Clutch (Waved) Plate NOTE: The tab on the clutch plate faces the bottom of the case.
2	1-2-3-4 Clutch Plate (Qty: 2) NOTE: The tab on the clutch plate faces the bottom of the case.
3	1-2-3-4 Clutch (w/Friction Material) Plate Assembly (Qty: 2)
4	Low and Reverse Clutch Assembly NOTE: The low and reverse clutch assembly should rotate freely in one direction and lock in the opposite direction. Rotate the clutch assembly and listen/feel for the ratchet of the clutch in it's designed rotational direction.
5	Low and Reverse Clutch Retaining Ring NOTE: The tab needs to go in groove at about 2 o'clock and snap ring opening needs to face 3 o'clock.