Headlamp Replacement (Chevrolet)

Fig 1: View Of Headlamp Assembly (Torrent)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Open the hood. Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement (Equinox) .
1	Headlamp Mounting Bolt (Qty: 4) CAUTION: Refer to Fastener Caution . NOTE: One screw is located at the front lower edge of the front fender outer panel at the bottom edge of the headlamp. Tighten 4.4 N.m (39 lb in)
2	Headlamp Ball Socket Locator Pin Procedure Pull from the bottom of the headlamp forward in order to release the headlamp locator pin from the front outer corner of the body rail. Disconnect the forward lamp harness electrical connector on the headlamp being serviced.
3	Headlamp Assembly Procedure Check and adjust the front headlamp aim after the headlamp have been reinstalled. Refer to Headlamp Aiming .