Control Valve Body Assembly Installation

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Control Valve Body Assembly Component View

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	NEW Fluid Pump Seal Assembly
2	NEW Fluid Pump Seal Assembly
3	NEW Center Support Fluid Passage Seal Assembly
4	Control Valve Body Assembly Tip: Align the manual shift shaft position switch activator slide with the detent lever guide pin.
5	Bolts M5 x 73 (Qty: 6) NOTE: Refer to Fastener Notice . Procedure: Tighten in the sequence shown. Tighten: 8 N.m (71 lb in). Special Tool: DT-48285 Valve Body Torx Plus Socket (if applicable). See Special Tools .