LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2013 >> Yukon Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1581 (Antilock Brake System - Non-Hybrid Less Than 3900 Kg (8600 Lb) GVW With TCS & VSES) >> Diagnostic Information and Procedures >> DTC C0455 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

With scan tool installed, clear the DTCs. Turn the steering wheel through its full range and back to straight ahead to center the steering angle sensor. Using a scan tool, observe the Steering Wheel Position parameter changes smoothly while turning steering wheel through the entire range. Correlate zero reading with wheels in the straight ahead position. Drive the vehicle through a variety of maneuvers turning to the left, right and then straight ahead at a speed greater than 20 km/h (13 mph).