Seat Belt Replacement - Center Rear (Crew Cab)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Seat Belt - Center Rear (Crew Cab)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove rear bench seat. Refer to Rear Seat Replacement (Crew Cab with A68) or Rear Seat Replacement (Extended Cab with AM7) or Rear Seat Replacement (Extended Cab with A68) .
1	Rear Center Seat Belt Anchor Plate Nut CAUTION: Refer to Fastener Caution . Tighten: 45 N.m (33 lb ft)
2	Rear Center Seat Belt Guide
3	Rear Center Seat Belt Retractor Bolt Tighten: 45 N.m (33 lb ft)
4	Rear Center Seat Belt Assembly Procedure Use a pry bar or flat-bladed tool to separate the seat belt buckle from the seat belt anchor plate. Route the seat belt through guide on the body rear inner panel.
5	Rear Seat Center Bracket Nut Tighten: 45 N.m (33 lb ft)
6	Rear Seat Center Bracket