Inflatable Restraint Passenger Presence System Replacement - Front (with HP2)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inflatable Restraint Passenger Presence System - Front (with HP2)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
WARNING: Refer to SIR Warning . Preliminary Procedure Remove the front seat. Refer to Front Seat Replacement - Bucket . Remove the seat cushion cover and pad. Refer to Seat Cushion Trim Cover and Pad Replacement .
1	Inflatable Restraint Front Passenger Presence Sensor Retainer (Qty: 2)
2	Inflatable Restraint Front Passenger Presence Sensor Procedure Lay the seat on its side. Unhook the connector from retainer on seat frame and push up through seat pan. Disconnect and remove the sensor.
3	Inflatable Restraint Front Passenger Presence Module Rivets (Qty: 2) Procedure: Drill out the rivets to remove and install using new rivets.
4	Inflatable Restraint Front Passenger Presence Module Procedure: The inflatable restraint passenger presence module must be replaced as a kit that also includes the sensor assembly.