Front Seat Cushion Outer Trim Panel Replacement (Manual)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Seat Cushion Outer Trim Panel (Manual)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Front Seat Recliner Lever Tip: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the lever.
2	Front Seat Manual Lumbar Knob Tip: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.
3	Front Seat Adjuster Outer Finish Cover CAUTION: Refer to Fastener Caution . Procedure Remove the screw from front of the cover. Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover. Pull outward to release the retainers from the seat assembly. Disconnect the electrical connectors. Tighten: 2 N.m (18 lb in)

Callout

Component Name

Front Seat Recliner Lever
Tip: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the lever.

Front Seat Manual Lumbar Knob
Tip: Using a flat-bladed tool, push the retainer clip downward and pull outward to release the knob.

Front Seat Adjuster Outer Finish Cover

CAUTION: Refer to Fastener Caution .

Procedure

Remove the screw from front of the cover.
Squeeze the tabs in the rear of the cover together to disengage the outer trim cover from the rear trim cover.
Pull outward to release the retainers from the seat assembly.
Disconnect the electrical connectors.

Tighten: 2 N.m (18 lb in)