LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2013 >> Yukon Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1131 (Sunroof System) >> Repair Instructions >> Sunroof Motor/Actuator Replacement

Sunroof Motor/Actuator Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Sunroof Motor/Actuator Replacement
GM1943748Courtesy of GENERAL MOTORS CORP.
Callout Component Name
Preliminary Procedure: 
It is only necessary to lower the headliner. Only perform the steps in the headliner replacement procedure that will lower the headliner enough to gain access to the part. Refer to Headlining Trim Panel Replacement .
1 Sunroof Motor/Actuator Bolt (Qty: 3)
NOTE: Refer to Fastener Notice .

Procedure

  1. Disconnect the electrical connector.
  2. With a turning motion, pull downward on the motor/actuator. Disengage the motor from the drive cables.
  3. Install the motor/actuator to the module with a turning motion. Push upward. This will engage the motor/actuator into the drive cables.

Tighten:  6 N.m (53 lb in).
2 Sunroof Motor/Actuator

Procedure

  1. Verify the sunroof operation.
  2. Sunroof track timing/synchronization. Refer to Sunroof Track Timing/Synchronization .
  3. After installing the sunroof motor/actuator refer to Sunroof Motor/Actuator Initialization/Teach Process .
scientia non olet · About LEMON Manuals