Input and Output Speed Sensor Replacement

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Input and Output Speed Sensor Component View

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the transmission fluid pan and filter. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement . Remove the upper and lower valve body assembly. Refer to Control Valve Lower Body and Upper Body Replacement . Disconnect the speed sensor electrical connector from the control solenoid valve assembly.
1	Input and Output Speed Sensor Assembly Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 12 N.m (106 lb in)
2	Input and Output Speed Sensor Assembly Procedure: Disconnect the speed sensor wiring harness clips. Inspect the clips for damage. Replace if damaged.
3	Control Valve Body Assembly