Headlamp Replacement (Chevrolet Tahoe Two-mode Hybrid)
Courtesy of GENERAL MOTORS COMPANY Headlamp Replacement (Chevrolet Tahoe Two-mode Hybrid)
| Callout |
Component Name |
|
Preliminary Procedures
- Remove the front bumper fascia. Refer to Front Bumper Fascia Replacement (Tahoe)
.
- Remove the 2 upper headlamp bolts.
- Grasp the headlamp at the upper inboard and lower outboard side and pull the headlamp forward to disengage the locating pins from the fender panel.
- Pull the outboard side of the headlamp forward until the locating pin is disengaged from the radiator support.
- Disconnect the electrical harness connector.
|
| 1 |
Headlamp Bolt
Tighten
6 N.m (53 lb in) |
| 2 |
Headlamp Bolt
Tighten
6 N.m (53 lb in) |
| 3 |
Forward Lamp Harness Electrical Connector |
| 4 |
Headlamp Assembly Procedure
- Upon re-assembly, align the locating tab along with the outer locating pins prior to applying inward pressure to the headlamp assembly.
- Aim the headlamp assembly. Refer to Headlamp Aiming (Tahoe/Yukon) .
|