Headlamp Replacement (Cadillac Escalade)

Fig 1: View Of Headlamp Assembly & Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Remove the 2 forward wheelhouse liner screws. Remove the 3 washer container push pins. Open the hood. Through the wheelhouse opening, loosen the lower headlamp bolt (1). Remove the 2 upper headlamp bolts. Grasp the headlamp at the upper inboard and lower outboard side and pull the headlamp forward to disengage from the snap feature. Pull the outboard side of the headlamp forward until the locating pins disengage from the radiator support. Disconnect the electrical harness connector.
1	Headlamp Lower Screw CAUTION: Refer to Fastener Caution . Tighten 6 N.m (53 lb in)
2	Headlamp Screw (Qty: 2) Tighten 6 N.m (53 lb in)
3	Headlamp Bracket TIP: Pull to release the headlamp tab from the bracket.
4	Forward Lamp Harness Electrical Connector
5	Headlamp Assembly