Tail Lamp Replacement (Tahoe, Yukon)
Tail Lamp Replacement (Tahoe, Yukon)
| Callout | Component Name |
|---|---|
| Preliminary Procedure Open the liftgate in order to access the tail lamp assembly screws. |
|
| 1 | Tail Lamp Assembly Screw (Qty: 2)
CAUTION:
Refer to Fastener Caution . Tighten 2 N.m (18 lb in) |
| 2 | Tail Lamp Assembly Locator Pin (Qty: 2) TIP: Upon tail lamp removal, some effort is needed to disengage the locating pins from the rear body panel retainer nuts. |
| 3 | Tail Lamp Retainer Nut (Qty: 2) |
| 4 | Tail Lamp Wiring Harness Assembly Connector |
| 5 | Tail Lamp Assembly TIP: Upon installation, push inward on the tail lamp in order to seat the 2 locating pins. |