LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2012 >> Yukon Base, RWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Lighting System >> Repair Instructions >> Spot Lamp Replacement (RPO 7X6, 7X7) >> Removal Procedure

Removal Procedure

    Fig 1: Spot Lamp Wiring Harness Push-In Retainer & Electrical Connector
    GM556316Courtesy of GENERAL MOTORS COMPANY
  1. Remove the spot lamp wiring harness push-in retainer from the windshield garnish molding, using a small flat bladed tool.
  2. Disconnect the electrical connector.
    3. Fig 2: Spot Lamp & Components
    GM555755Courtesy of GENERAL MOTORS COMPANY
  3. Remove the spot lamp handle wedge key screw from the spot lamp handle.

    Loosen the wedge key screw a few turns then with a light tap with a suitable hammer to the wedge key screw will loosen it from the spot lamp outer tube shaft.

  4. Remove the spot lamp handle from the outer tube shaft.
  5. Remove the rubber grommet from the outer tube shaft.
    6. Fig 3: Spot Lamp Bracket Set Screw
    GM556312Courtesy of GENERAL MOTORS COMPANY
  6. Loosen the spot lamp bracket set screw.
    7. Fig 4: Spot Lamp Mounting Bracket Screws
    GM555754Courtesy of GENERAL MOTORS COMPANY
  7. Pull the spot lamp with the outer tube shaft out of the spot lamp mounting bracket and set aside.
  8. Remove the spot lamp mounting bracket screws.
  9. Remove the mounting bracket and the gasket from the windshield pillar.
  10. Clean the mounting surface of the windshield pillar.
scientia non olet · About LEMON Manuals