LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2012 >> Acadia SLT, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays And Gauges >> Diagnostic Information and Procedures >> Engine Oil Pressure Indicator Malfunction >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the EOP switch.
  2. Ignition OFF, test for less than 1 ohm between the low reference circuit terminal B and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  3. Ignition ON, verify the scan tool Engine Oil Pressure Switch parameter is OK.
    • If not the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the ECM.
  4. Ignition ON, install a 3 A fused jumper wire between the signal circuit terminal A and the ground circuit terminal B. Verify the scan tool Engine Oil Pressure Switch parameter is Low.
    • If not the specified value, test the signal circuit for an open/high resistance. If circuit test normal, replace the ECM.
  5. Ignition ON, command the IPC indicators OFF with the scan tool.
    • If the EOP indicator does not turn OFF, replace the IPC.
  6. If all circuits test normal, test or replace the engine oil pressure switch.
scientia non olet · About LEMON Manuals