Front Seat Belt Anchor Plate Tensioner Replacement

Fig 1: View Of Driver or Passenger Seat Belt Tensioner

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
WARNING: Refer to SIR Warning . WARNING: In order to prevent accidental deployment and the risk of personal injury, do not dispose of an undeployed inflatable restraint seat belt pretensioner as normal shop waste. Undeployed seat belt pretensioners contain substances that could cause severe illness or personal injury if their sealed containers are damaged during disposal. Use the following deployment procedures to safely dispose of an undeployed seat belt pretensioner. Failure to observe the following disposal methods may be a violation of federal, state, or local laws. WARNING: Refer to SIR Inflator Module Handling and Storage Warning . Preliminary Procedures Move the front seat to the full forward and full up position. Disable the SIR. Refer to SIR Disabling and Enabling . Remove the front seat outer recliner finish cover. Refer to Front Seat Back Recliner Outer Trim Panel Replacement . For pretensioner handling and scrapping refer to Pretensioner Handling and Scrapping .
1	Seat Belt Tensioner Bolt CAUTION: Refer to Fastener Caution . Tighten 45 N.m (33 lb ft)
2	Front Seat Shoulder Belt Anchor Plate Bolt Tighten 6 N.m (53 lb in)
3	Driver Seat Belt (Retractor Side) Tensioner Procedure Disconnect the electrical connector.