Stabilizer Shaft Insulator Replacement (1500)

Fig 1: Stabilizer Shaft Insulator (1500)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
1	Stabilizer Shaft Clamp Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 50 N.m (37 lb ft)
2	Stabilizer Shaft Clamp
3	Stabilizer Shaft Insulator TIP: Ensure that the slit in the stabilizer shaft insulator is installed toward the rear of the vehicle.