LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Automatic Transmission - 2ML70 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Auxiliary Fluid Pump Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Auxiliary Fluid Pump Control Module
    GM1975204Courtesy of GENERAL MOTORS CORP.
  1. Install the auxiliary fluid pump control module (2) to the engine control module bracket.
  2. Install the auxiliary fluid pump control module electrical connector (1) to the auxiliary fuse block.
    3. Fig 2: Auxiliary Fluid Pump Control Module Electrical Connector
    GM1975207Courtesy of GENERAL MOTORS CORP.
  3. Connect the auxiliary fluid pump control module electrical connector (1) to the engine wiring harness electrical connector (2).
    4. Fig 3: Auxiliary Fluid Pump Electrical Wire Harness Connector
    GM1975037Courtesy of GENERAL MOTORS CORP.
  4. Connect the auxiliary fluid pump electrical wire harness connector (1) to the auxiliary fluid pump control module connector (2).
scientia non olet · About LEMON Manuals