LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Electrical - Hybrid) >> Repair Instructions >> Generator Control Module Ground Strap Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Motor Generator Control Module Ground Strap And Bolt
    GM1968778Courtesy of GENERAL MOTORS CORP.
  1. Position the ground strap (2) to the drive motor generator control module.
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the ground strap bolt (1) and tighten to 9 N.m (80 lb in).
  3. Install the air cleaner assembly. Refer to Upper Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals