Holding Fixture Installation and Torque Dampener Removal

WARNING: This page is about a different variant/trim than selected.

Fig 1: Holding Fixture And Torque Dampener

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	A/Trans Torque Dampener Assembly Special Tool J 21366 Converter Holding Strap
2	A/Trans Case Assembly Procedure Rotate the transmission so that the dampener housing is up and secure with locking pin. Allow any remaining transmission fluid to drain from the case extension. Special Tools DT-48307 Holding Fixture J 3289-20 Holding Fixture Base Assembly

Callout

Component Name

A/Trans Torque Dampener Assembly
Special Tool
J 21366 Converter Holding Strap

A/Trans Case Assembly

Procedure

Rotate the transmission so that the dampener housing is up and secure with locking pin.
Allow any remaining transmission fluid to drain from the case extension.

Special Tools