LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Oil Level Indicator and Tube Removal

Oil Level Indicator and Tube Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Oil Level Indicator And Tube
    GM1658141Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil level indicator (418) from the tube.
  2. Remove the oil level indicator tube bolt (419).
  3. Remove the oil level indicator tube (420) from the engine block.
    4. IMPORTANT:

    Inspect the O-ring for cuts or damage. The O-ring seal may be used again if it is not cut or damaged.

  4. Remove the O-ring (421) from the tube, as required.
scientia non olet · About LEMON Manuals