LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 24 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Automatic Transmission Flex Plate Removal

Automatic Transmission Flex Plate Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Automatic Transmission Flex Plate
    GM1967302Courtesy of GENERAL MOTORS CORP.
    IMPORTANT:

    The flex plate does not use a locating pin for alignment and will not initially seat against the crankshaft flange, but will be pulled onto the crankshaft by the engine flex plate bolts. This procedure requires a 3 stage tightening process.

  1. Remove the engine flex plate bolts.
  2. Remove the flex plate.
scientia non olet · About LEMON Manuals