LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Drive Belt Idler Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Drive Belt Idler Pulley
    GM1959938Courtesy of GENERAL MOTORS CORP.
  1. Install the drive belt idler pulley (2) and bolt to the generator bracket.

    Snug the bolt finger tight.

    2. CAUTION:

    Refer to Fastener Caution .

  2. Tighten the drive belt idler pulley bolt (1).

    Tighten 

    Tighten the bolt to 50 N.m (37 lb ft).

  3. Install the drive belt. Refer to Drive Belt Replacement .
scientia non olet · About LEMON Manuals