LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Camshaft Position Actuator Magnet Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: CMP Actuator Magnet, Bolts, Gasket And Oil Seal
    GM1658168Courtesy of GENERAL MOTORS CORP.
  1. Remove the water pump. Refer to Water Pump Replacement .
  2. Disconnect the engine harness electrical connector from the camshaft position (CMP) actuator magnet.
  3. Remove the CMP actuator magnet bolts (751) and magnet (752).
  4. Remove and discard the CMP actuator magnet gasket (753).
scientia non olet · About LEMON Manuals