LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Transfer Case Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Transfer Case Shield And Bolts
    GM1696787Courtesy of GENERAL MOTORS CORP.
  1. Position the transfer case shield (1, 3, and 4).
    2. CAUTION:

    Refer to Fastener Caution .

  2. Install the transfer case shield bolts (2 or 5).

    Tighten 

    Tighten the bolts to 20 N.m (15 lb ft).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals