LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Transfer Case Rear Extension Bushing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Installing Output Shaft Bushing
    GM1549538Courtesy of GENERAL MOTORS CORP.
    NOTE:

    Install the bushing with the notched area facing outward and properly aligned to the rear case. Oil pick up "slot" should be straight down in the vehicle.

  1. Using J 45380 install the output shaft bushing, if removed or new.
  2. Install the rear output shaft seal. Refer to Rear Output Shaft Seal Replacement .
scientia non olet · About LEMON Manuals