LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Input Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Input Shaft Seal And Special Tool
    GM1728908Courtesy of GENERAL MOTORS CORP.
  1. Using the J 42738 , install the input shaft seal.
  2. Install the transfer case. Refer to Transfer Case Assembly Replacement .
scientia non olet · About LEMON Manuals