Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTC P0641 or P0651 is not set.
- The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
- The ignition is ON or the engine is operating.
- DTC P0120, P0122, P0123, P0220, P0222, P0223, and P2135 run continuously when the above conditions are met.
P2135
- DTC P0120, P0220, P0641, P0651 are not set.
- The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
- The ignition is ON or the engine is operating.
- DTC P2135 runs continuously when the above conditions are met.