Conditions for Running the DTC

P0030, P0036, P0050, or P0056

• The ignition voltage is between 11-32 V.
• The engine speed is greater than 400 RPM.
• The DTCs run continuously when the above conditions are met for 1 s.

P0053, P0054, P0059, or P0060

• DTCs P0112, P0113, P0117, P0118, or P2610 are not set.
• The engine is started.
• The ignition voltage is less than 18 V.
• The ignition is OFF for greater than 8 hours.
• The engine coolant temperature (ECT) is between -30 to +45°C (-22 to +113°F) at engine start-up.
• The ECT minus the intake air temperature (IAT) is less than 8°C (14°F) at engine start-up.
• The DTCs run once per drive cycle when the above conditions are met.

P0135, P0141, P0155, or P0161

• DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0455, P0496, P1516, P2101, P2119, P2135, or P2176 are not set.
• The engine coolant temperature (ECT) is greater than 50°C (122°F).
• The ignition voltage is between 10-32 V.
• The engine run time is greater than 300 s.
• The engine speed is between 500-3, 000 RPM.
• The DTCs run once per drive cycle when the above conditions are met for 120 s.