Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
P2120, P2122, P2123, P2125, P2127, P2128
- DTC P0641 and P0651 are not set.
- The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
- The ignition is in the Unlock/Accessory or Run position.
- DTC P2120, P2122, P2123, P2125, P2127, P2128 run continuously when the above conditions are met.
P2138
- DTC P0641, P0651, P2120, P2125 are not set.
- The system voltage is greater than 5.23 V.
- The ignition is in the Unlock/Accessory or Run position.
- DTC P2138 runs continuously when the above conditions are met.