Conditions for Running the DTC

P1516 and P2101

• DTC P0606 and P1682 is not set.
• The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
• The engine is running or the following conditions are met:
  • The engine is not running.
  • The ignition voltage is greater than 11 V.
  • The TAC system is not in the Battery Saver mode.
  • The ECM is commanding the throttle.
  • The ECM has learned the minimum throttle position.
• DTC P1516 and P2101 run continuously when the above conditions are met.

P2119

• DTCs P0120, P0122, P0123, P0220, P0222, P0223 are not set.
• The ignition is ON.
• The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
• The ECM is not commanding the throttle blade.
• DTC P2119 runs continuously when the above conditions are met.

P2176

• DTCs P0120, P0121, P0122, P0123, P0220, P0222, P0223, or P1682 is not set.
• The ignition is ON.
• The run/crank or powertrain relay voltage is greater than 6 V and reduced power is not active.
• The ECM enable the minimum throttle learn procedure.
• DTC P2176 run continuously when the above conditions are met.