LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 2ML70 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Transmission Fluid Level and Condition Check >> Notes

Transmission Fluid Level and Condition Check: Notes

WARNING: This page is about a different variant/trim than selected.
  1. Start the engine and operate the vehicle for 15 minutes or until the transmission fluid reaches an operating temperature of 65-80°C (150-180°F).
  2. Park the vehicle on a level surface.
  3. With your foot on the brake, move the shift lever through each gear range. Pause for about 3 seconds in each range, ending in PARK.
  4. Apply the parking brake and let the engine idle for 3 minutes.
  5. Remove the transmission fluid level indicator. Wipe the indicator clean. Insert the indicator by pushing it back in all the way. Give the indicator a full twist in order to close.
  6. Wait 3 seconds and remove the indicator.
  7. Read both sides of the indicator. The fluid must be within the hot cross-hatched area using the lowest level reading.
scientia non olet · About LEMON Manuals