Reset Transmission Adapts: Troubleshooting

WARNING: This page is about a different variant/trim than selected.

If the Reset Transmission Adapts will not run and the above stated conditions have been met, ensure the following:

Trans. Fluid Temp. parameter is between 70-115°C (158-239°F).
Brakes and brake switch are functioning properly.
No active DTCs.
Closed throttle and engine RPM increases above 1500 RPM while at entrance of the test.
Park/Neutral position switch is properly adjusted and functioning.
Line pressure control is able to provide 1000 kPa and is within specifications.
Vehicle is not moving, or vibrating excessively.
Clutches are properly assembled.