LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Automatic Transmission - 2ML70 - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2714 or P2715 >> Conditions for Setting the DTC

Conditions for Setting the DTC

WARNING: This page is about a different variant/trim than selected.

P2714 - Condition 1 

The clutch pressure control solenoid 4 commanded pressure is 1800 kPa (261 psi) and the TFP switch 4 state parameter is Low for 30 seconds.

P2714 - Condition 2 

The clutch pressure control solenoid 4 commanded pressure is 1800 kPa (261 psi) and the TFP switch 4 state parameter is Low for 0.5 seconds greater than 5 times during a key cycle.

P2715 - Condition 1 

The clutch pressure control solenoid 4 commanded pressure is 5 kPa (1 psi) and the TFP switch 4 state parameter is High for 30 seconds.

P2715 - Condition 2 

The clutch pressure control solenoid 4 commanded pressure is 5 kPa (1 psi) and the TFP switch 4 state parameter is High for 0.02 seconds greater than 5 times during a key cycle.

scientia non olet · About LEMON Manuals