LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Yukon Base, 5.3 3 >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls And Fuel - Hybrid (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Line Replacement - Canister to Tank >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Fuel Tank EVAP Lines
    GM1704507Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP lines to the fuel tank.
    2. Fig 2: Fuel Tank Clips
    GM1704505Courtesy of GENERAL MOTORS CORP.
  2. Connect the EVAP line quick connect fittings at the fuel tank module and vent valve. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the EVAP lines to the fuel tank clips (1, 3, 4, and 5) and close the clips.
  4. Install the EVAP lines to the fuel tank clips (2, and 6).
    5. Fig 3: Fuel Tank Shield And Retainers
    GM1704741Courtesy of GENERAL MOTORS CORP.
  5. Install the fuel tank shields (1, and 4) and retainers (2, and 3).
  6. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals