Rear Crankshaft Main Bearing Seal: Service and Repair

Crankshaft Rear Oil Seal Replacement

Special Tools

EN-42067 - Rear Main Seal Installer

For equivalent regional tools, refer to Special Tools (Special Tools).

Removal Procedure




1. Remove the flywheel. Refer to Engine Flywheel Replacement (Service and Repair).

Note: Do not damage the outside diameter of the crankshaft or chamber with any tool.

2. Pry out the crankshaft rear oil seal using a flat-bladed tool.

Installation Procedure




1. Using the EN-42067 - installer , install a NEW crankshaft real oil seal.
2. Install the flywheel. Refer to Engine Flywheel Replacement (Service and Repair).