Transmission Mount Replacement (Z85 and ZQ8)

Transmission Mount Replacement (RPO Z85 and ZQ8)

Removal Procedure




1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Support the transmission with a transmission jack.
3. Remove the two nuts (1) securing the transmission mount to the transmission support.
4. Raise the transmission off of the transmission support.




5. Remove the mount to transmission bolts.

Installation Procedure




1. Install the transmission mount to the vehicle.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the mount to transmission bolts and tighten to 55 Nm (41 lb ft).




3. Lower the transmission and install the two nuts (1) securing the transmission mount to the transmission support. Tighten the nuts to 57 Nm (42 lb ft).
4. Remove the transmission jack.
5. Lower the vehicle.