Spring Bumper Replacement (Z85, ZQ8)

Spring Bumper Replacement (2WD, Z85, ZQ8)

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




2. Remove the jounce bumper mounting bolts.
3. Remove the jounce bumper.

Installation Procedure




1. Install the jounce bumper.

Caution: Refer to Fastener Caution (Fastener Caution).

2. Install the jounce bumper bolts and tighten to 32 Nm (24 lb ft).
3. Lower the vehicle.