Rear Seat Cushion Cover and Pad Replacement (with 40 Percent Seat)

Preliminary Procedures

1. Move the seat to the Smart Slide® E-Z entry position.
2. Remove the rear seat cushion trim panels. Refer to Rear Seat Cushion Trim Panel Assembly Replacement - Outboard (with 60 Percent Seat) , Rear Seat Cushion Trim Panel Assembly Replacement - Outboard (with 40 Percent Seat) , or Rear Seat Cushion Trim Panel Assembly Replacement - Inboard (with 40 Percent Seat) , Rear Seat Cushion Trim Panel Assembly Replacement - Inboard (with 60 Percent Seat) .
3. Remove the rear seat cushion front cover. Refer to Rear Seat Cushion Front Cover Replacement (with 40 Percent Seat) .

Procedure

1. Disengage the seat cushion cover j-channel from the seat cushion frame.
2. Remove the hog rings that retain the rear of the seat cushion cover to the frame.
3. Disconnect the rear seat latch cables.
4. Remove the rear seat cushion cover and pad as an assembly.

Procedure

1. Disengage the hog rings retaining the cover to the pad.
2. Separate the seat cushion cover from the pad.