LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Acadia SL, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System >> Diagnostic Information and Procedures >> Stop Lamps Malfunction >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON, observe the scan tool BPP Sensor parameter while applying and releasing the brake pedal. The parameter should change between low counts and high counts when changing between the selected states.
    • If the parameter does not change between the selected states, refer to the Brake Pedal Position Sensor Malfunction.
  2. Observe the left and right stop lamps while pressing and releasing the brake pedal. The stop lamps should turn ON and OFF when changing between the selected states.
    • If the left or right stop lamps do not change between the selected states, refer to the Stop Lamp Malfunction.
  3. Observe the center high mount stop lamp while pressing and releasing the brake pedal. The center high mount stop lamp should turn ON and OFF when changing between the selected states.
    • If the center high mount stop lamp does not change between the selected states, refer to Center High Mount Stop Lamp Malfunction.
scientia non olet · About LEMON Manuals