LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Acadia SL, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Illumination Lights >> Lighting System >> Diagnostic Information and Procedures >> Headlamps Malfunction >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON, observe the scan tool Auto Hdlp. Disable Sw. parameter while turning the headlamp switch ON and OFF. The parameter should change between Active and Inactive.
    • If the reading does not change between the selected states, refer to Headlamp Switch Malfunction.
  2. Observe the scan tool Headlamp Switch parameter while turning the headlamp switch ON and OFF. The parameter should change between Active and Inactive.
    • If the reading does not change between the selected states, refer to Headlamp Switch Malfunction.
  3. Observe the scan tool Flash To Pass Switch parameter while applying and releasing the flash to pass switch. The reading should change between Active and Inactive.
    • If the reading does not change between the selected states, refer to Turn Signal/Multifunction Switch Malfunction.
  4. Observe the scan tool High Beam Select switch parameter while applying and releasing the high beam select switch. The reading should change between Active and Inactive.
    • If the reading does not change between the selected states, refer to Turn Signal/Multifunction Switch Malfunction.
  5. Command the Low Beams ON and OFF with a scan tool. The low beam headlamps should turn ON and OFF when changing between the commanded states.
    • If the low beam headlamps do not turn ON and OFF when commanded, refer to Headlamps Malfunction - Low Beam.
  6. Command the High Beams ON and OFF with a scan tool. The high beam headlamps should turn ON and OFF when changing between the commanded states.
    • If the high beam headlamps do not turn ON and OFF when commanded, refer to Headlamps Malfunction - High Beam.
  7. Command the Lamp Test ON and OFF with a scan tool. The lights on indicator and high beam indicator should turn ON and OFF when changing between the commanded states.
    • If the lights on indicator and high beam indicator illuminate during the test, replace the BCM.
    • If the lights on indicator and high beam indicator do not illuminate during the test or remain illuminated at all times, replace the instrument cluster.
scientia non olet · About LEMON Manuals