Luggage Carrier Side Rail Rear Finish Cover Replacement
Luggage Carrier Side Rail Rear Finish Cover Replacement
| Callout | Component Name |
|---|---|
| 1 | Luggage Carrier Finish Cover (Qty: 2) Procedure The luggage carrier finish cover does not have a push in pin release. The cover can be removed by using a flat bladed tool. Carefully pry upward on a corner of the cover releasing it fully from the clips. |
| 2 | Luggage Carrier Finish Cover Clip (Qty: 2) |
| 3 | Luggage Carrier Fastener (Qty: 7)
CAUTION:
Refer to Fastener Caution . TIP: Use care after removing the luggage rail fasteners that the rail does not slide causing damage to the roof surface. Tighten 5 N.m (44 lb in). |
| 4 | Luggage Carrier Rail TIP: Before installing the finish cover align the alignment pin to the hole in the luggage rail before fully seating the cover on the clips. |