Rear Side Door Lower Molding Replacement (Acadia)
Rear Side Door Lower Molding Replacement (Acadia)
| Callout | Component Name |
|---|---|
| Preliminary Procedure Using a J 25070 heat gun in a circular motion, warm the front side door molding prior to removal. Carefully clean the body panel thoroughly prior to bonding the new lower body side molding to the door. Special Tools J 25070 Heat Gun |
|
| 1 | Rear Side Door Lower Molding Locating Pin Procedure Align the pin to the center of the door prior to securing the retainers. |
| 2 | Rear Side Lower Door Molding Procedure Secure the molding to the door and remove the protective liner on the backside of the molding after all of the retainers are secure. |
| 3 | Lower Molding Integral Retainer (Qty: 10) |