Liftgate Emblem/Nameplate Replacement (Enclave Nameplate)

Procedure

1. Use a J 25070  heat gun or equivalent to remove the old emblem. Clean all the adhesive residue from the liftgate, wipe the surface dry with a clean lint-free towel prior to installing new emblem.
2. When removing protective liners from adhesive backed emblems, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
3. Close the liftgate prior to installing the new emblem to the liftgate.
4. Remove the protective liner from the back side of the adhesive tape.
5. Align the emblem to the liftgate and press to ensure full adhesion is made.

Procedure

1. Use a J 25070  heat gun or equivalent to remove the old emblem. Clean all the adhesive residue from the endgate, wipe the surface dry with a clean lint-free towel prior to installing new emblem.
2. When removing protective liners from adhesive backed emblems, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
3. Close the liftgate prior to installing the new emblem to the liftgate.
4. Remove the protective liner from the back side of the adhesive tape.
5. Align the emblem to the liftgate and press to ensure full adhesion is made.

Procedure

1. Use a J 25070  heat gun or equivalent to remove the old nameplate. Clean all the adhesive residue from the liftgate, wipe the surface dry with a clean lint-free towel prior to installing new nameplate.
2. When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
3. Close the liftgate prior to installing the new nameplate to the liftgate.
4. Remove the protective liner from the back side of the adhesive tape.
5. Align the nameplate to the liftgate and press to ensure full adhesion is made.