Liftgate Emblem/Nameplate Replacement (AWD Acadia)

Fig 1: Identifying Liftgate Emblem & Nameplate (AWD)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Liftgate Nameplate/Emblem CAUTION: Refer to Exterior Trim Emblem Removal Caution . Procedure Use a J 25070 heat gun or equivalent to remove the old nameplate. Clean all the adhesive residue from the liftgate, wipe the surface dry with a clean lint-free towel prior to installing new nameplate. When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion. Close the liftgate prior to installing the new nameplate/emblem to the liftgate. Remove the protective liner from the back side of the adhesive tape. Align the nameplate/emblem to the liftgate and press to ensure full adhesion is made.

Callout

Component Name

Liftgate Nameplate/Emblem

CAUTION:

Procedure

Use a J 25070 heat gun or equivalent to remove the old nameplate. Clean all the adhesive residue from the liftgate, wipe the surface dry with a clean lint-free towel prior to installing new nameplate.
When removing protective liners from adhesive backed nameplates, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
Close the liftgate prior to installing the new nameplate/emblem to the liftgate.
Remove the protective liner from the back side of the adhesive tape.
Align the nameplate/emblem to the liftgate and press to ensure full adhesion is made.