Front Fender Wheel Opening Molding Replacement (Enclave)

Fig 1: Identifying Front Fender Wheel Opening Molding (Enclave)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Release the five forward and six rearward wheelhouse liner screws to allow for the repositioning of the liner. Remove the five screws from the front portion of the wheelhouse liner to fender flange. Remove the three upper fender molding to fender flange push pin retainers. Remove the six rearward flare to fender flange screws. Release the retainer clips, three forward and two rearward from the fender flange.
1	Front Wheel Opening Molding Screw (Qty: 5) CAUTION: Refer to Fastener Caution . Tighten 1.5 N.m (13 lb )
2	Retainer Clips (Qty: 5) TIP: Release the clips from inside the fender flange.
3	Front Wheel Opening Molding Assembly