Front Fender Wheel Opening Molding Replacement (Acadia)

Fig 1: Identifying Front Fender Wheel Opening Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to Exterior Trim Emblem Removal Caution . Preliminary Procedures Using a 50/50 mixture of isopropyl alcohol and clean drinkable water and a clean towel, remove the left over adhesive residue from the flare. Wipe the fender with a clean dry towel. Peel the adhesive tape backing from the fender wheel molding. Secure the fender wheel molding starting at the center and working outward. Completely wet out the fender wheel molding.
1	Integral Tabs (Qty: 9)
2	Integral Clips (Qty: 2)
3	Front Wheelhouse Molding