LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Engine Mechanical - 2.8L Or 3.0L - Repair Instructions - Off Vehicle (4 Of 5)) >> Engine Flywheel Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the engine flywheel in position on the crankshaft.
  2. Install 2 NEW bolts in location at the top and bottom of the engine flywheel bolt pattern allowing the engine flywheel to hang in position.
    3. Fig 1: Identifying Special Tool - EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  3. Install the EN 46106:  tool.
    4. Fig 2: View Of Engine Flywheel Bolts
    GM1871066Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Install the remaining NEW engine flywheel bolts.
    1. Tighten the NEW engine flywheel bolts to 30 N.m (22 lb ft) .
    2. Tighten the NEW engine flywheel bolts an additional 45 degrees using the EN 45059:  meter .
    5. Fig 3: Identifying Special Tool - EN 46106
    GM945978Courtesy of GENERAL MOTORS CORP.
  5. Remove the EN 46106:  tool.
scientia non olet · About LEMON Manuals