LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2011 >> Acadia Denali, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 103 (Engine Mechanical - 2.8L Or 3.0L - Repair Instructions - Off Vehicle (4 Of 5)) >> Camshaft Cover Installation - Right Side (LF1) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Spark Plug Tubes
    GM1836418Courtesy of GENERAL MOTORS CORP.
  1. Install the EN-46101:  guide onto the spark plug tubes of the right cylinder head.
    2. Fig 2: View Of Right Camshaft Cover Bolt Grommets
    GM1836419Courtesy of GENERAL MOTORS CORP.
  2. Install the NEW camshaft cover bolt grommets prior to installing the camshaft cover bolts.
  3. Wipe the camshaft cover sealing surface on the right cylinder head with a clean, lint-free cloth.
    4. Fig 3: Identifying Engine Front Cover Split Lines
    GM1836422Courtesy of GENERAL MOTORS CORP.
  4. Place a bead 8 mm (0.3150 in) in diameter by 4 mm (0.1575 in) in height of RTV sealant on the engine front cover split lines (1). Refer to Adhesives, Fluids, Lubricants, and Sealers for recommended sealant.
    5. Fig 4: View Of Right Camshaft Cover
    GM1836426Courtesy of GENERAL MOTORS CORP.
  5. Place the right camshaft cover into position onto the right cylinder head.
    6. Fig 5: Locating Right Camshaft Cover Bolts
    GM1836430Courtesy of GENERAL MOTORS CORP.
  6. Loosely install the right camshaft cover bolts.
    7. Fig 6: Identifying Right Camshaft Cover Bolt Tightening Sequence
    GM1992550Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  7. Tighten the right camshaft cover bolts in the sequence shown.
    • Tighten the right camshaft cover bolts to 10 N.m (89 lb in) .
    • Tighten the right camshaft cover bolts a second pass to 10 N.m (89 lb in) .
    8. Fig 7: View Of Spark Plug Tubes
    GM1836434Courtesy of GENERAL MOTORS CORP.
  8. Remove the EN-46101:  guide from the spark plug tubes of the right cylinder head.
    9. Fig 8: View Of Spark Plugs
    GM1836414Courtesy of GENERAL MOTORS CORP.
  9. Install the NEW spark plugs into the right cylinder head and tighten to 20 N.m (15 lb ft).
    10. Fig 9: View Of Ignition Coils
    GM1836413Courtesy of GENERAL MOTORS CORP.
  10. Install the ignition coils.
    11. Fig 10: Identifying Ignition Coil Bolts
    GM1836412Courtesy of GENERAL MOTORS CORP.
  11. Install the ignition coil bolts and tighten to 10 N.m (89 lb in).
scientia non olet · About LEMON Manuals