Driver Knee Bolster Replacement (Enclave)

Fig 1: Identifying Driver Knee Bolster (Enclave)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the hood latch release handle assembly. Refer to Hood Primary Latch Release Cable Handle Replacement .
1	Driver Knee Bolster Screw (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 2.5 N.m (22 lb in)
2	Driver Knee Bolster Assembly Procedures Disconnect the electrical connections. When replacing the knee bolster, transfer all necessary components.
3	Retainer Clip (Qty: 5)